Osd-audio Soundsole 2.1 User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
Congratulations and thank you for purchasing OSD AUDIO SOUNDSOLE 2.1 Desk/Table-Top All in One System.
The OSD AUDIO SOUNDSOLE 2.1 greatly enhances the sound quality of today’s flat screen LED, LCD and Plasma
TVs without having to add a lot of speakers. A single speaker system that requires very little space, the SOUNDSOLE
2.1 can be installed below or in front of a high definition TV or inside a cabinet. You’ll enjoy simulated surround sound
from a single, space- saving cabinet with deep, enveloping bass without bulky speakers or amps. The OSD AUDIO
SOUNDSOLE 2.1 easily connects to inputs on today’s flat panel TVs and digital music players and even syncs to
almost any Bluetooth audio device.
OSD Audio
SOUND SOLE 2.1
FRONT PANEL
1. STATUS LED - (Behind front panel lens.) One multi-color LED. This LED will illuminate red/blue and flash in
different modes to indicate changes in the SOUNDSOLE 2.1operational status. SOLID RED - OFF (Standby).
Power cord is connected and AC switch is turned ON, but the SOUNDSOLE 2.1 is OFF.
SOLID BLUE ON OSD AUDIO SOUNDSOLE 2.1 is ON.
SINGLE BLUE FLASH - Confirms receiving an IR command from the OSD AUDIO SOUNDSOLE 2.1
Remote for changes to Treble/Bass, EQ Reset, Simulated Surround (SR), single Volume UP/DOWN
command, initiating output of the Bluetooth Connection Code.
RAPID BLUE FLASH - Confirms receiving a continuous IR stream from the SOUNDSOLE 2.1 Remote
for ramping volume UP/DOWN. Rapid blue flash also indicates the SOUNDSOLE 2.1 is in Bluetooth
pairing mode.
SLOW BLUE FLASH - Audio Mute. Audio signal to the speakers is turned OFF.
TWO BLUE FLASHES; DELAY - Bluetooth input is selected and no Bluetooth device is connected or it is
out of range.
2. IR SENSOR - (Behind front panel lens.) The IR Sensor ‘sees’ the IR control commands output from the
SOUNDSOLE 2.1 IR Remote Control when buttons are pressed on the remote for armchair control of the
SOUNDSOLE 2.1. This sensor must be unobstructed for direct line-of-sight to the remote, or the remote will not
be able to control the SOUNDSOLE 2.1.
1
2
Page 5
OSD Audio · 775 Columbia Street · Brea, CA 92821 · Tel: (562) 697-2600 · www.osdaudio.com
Page view 4
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments